To change the component macro executing time – Sony RM-AV3000T User Manual
Page 42
Advertising
42
To change the component
macro executing time
1 Follow the procedure of Steps 1 -
5 on page 40.
2
Press the TIME key.
The current component macro executing
time stays lit, and (+) and (–) flash.
3
Press the (+) or (–) key to change
the component macro executing
time. You can control the time
from 0 to 2 sec (seconds) in units
of 1 sec.
Each time you the (+) key is pressed,
the time increased by 1 sec.
Each time you the (–) key is pressed,
the time decreases by 1 sec.
Executing a Series of Commands
— System Control Functions
(continued)
4
Press COMMANDER OFF.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the
previous setting mode.
COMMANDER
OFF
Advertising