Sony RM-AV3000T - Manual (Page 51)

51
COMMANDER
OFF
To clear the learned remote
control signal
1 While pressing COMMANDER OFF,
press %.
2 Press the LEARN key.
“LEARN” appears on the Mode
Display key.
3 While pressing the DEL key, press the
SYSTEM CONTROL button or the
Label key of which learned signals are
to be cleared.
The learned signals are cleared.
4 Press COMMANDER OFF.
If you want to programme a new signal
for that button, follow Steps 4 to 6 in the
left column.
If you keep COMMANDER OFF pressed
for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF pressed
for less than 2 seconds
The Commander returns to the previous
setting mode.
Continued
5
Press and hold down the button
of the remote control until you
hear a beep.
(If you release the button before you
hear a beep, the signal may not be
learned correctly.)
While receiving the signal, “LEARN”
stays lit.
If “NG” flashes on the display and
“NG” sound is heard five times
Learning did not succeed. Try Steps 4 and
5 again.
6
Press COMMANDER OFF.
Note
You cannot programme a remote control signal
for a SYSTEM CONTROL button or a Label key
by “learning” for which the System Control
function have been programmed. If you want to
programme a remote control signal for that
button, clear programmed commands first
(page 35).
If you keep COMMANDER OFF pressed
for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF pressed
for less than 2 seconds
The Commander returns to the previous
setting mode.