Sony RM-AV3000T - Manual (Page 56)

56
ALL
Transferring Data between
Commanders (continued) “ALL x” appears on the Mode
Display key, and “ALL” appears on
the left Label key.
4
Press the ENTER key.
During receiving the data,
“
cccc cccc” flashes.
When all the data has been
successfully transferred, “ALL”
appears on the right Label key.
Notes
• If the Commander is not ready for
receiving the data, press the CLEAR key,
then press the RETURN key to clear all
the learned signals.
• If “NG” appears during data transfer, go
back to Step 3 and continue the operation
or press COMMANDER OFF to stop the
operation. If you continue the operation,
you have to set the sending Commander
again to send data.
Receiving the data
This Commander can receive the data of
another Sony RM-AV3000T.
To receive all the data from
another remote commander
1
Follow Steps 1 to 5 on page 53.
2
Press the x key.
X : Transfer data
x : Receive data
3
Press the ALL key.
ALL: All data of the Commander
COMPO: Data of a Component
Select button or a Label key