Sony 3-270-589-12 (1) - Manual (Page 22)

22
Names and Functions of Parts
Ch
apt
er 1 Ov
e
rv
ie
w
1 Analog video signal input/output
section
a REF VIDEO INPUT (reference video signal input)
connectors (BNC type)
The two connectors form a loop-through connection; when
a reference video signal is input to the left connector, the
same signal is output from the right connector (
) to a
connected device. When no connection is made to the right
connector, the left connector is automatically terminated
with an impedance of 75 ohms.
b COMPOSITE OUTPUT connectors (phono jack,
BNC type)
These output composite video signals.
When CHAR SEL on page P1 of the function menu is set
to “ON”, and DISPLAY CONTROL >SD CHARA in the
setup menu is set to “COMPOSITE” or “ALL”,
information such as timecode, menu settings, and error
messages is superimposed on the output signals (see page
40).
c MONITOR connector (D-sub 15-pin)
This outputs HD analog video signals. The output signals
can be switched with INTERFACE SELECT >D-SUB
OUTPUT in the setup menu (see page 102).
When CHAR SEL on page P1 of the function menu is set
to “ON”, and DISPLAY CONTROL >HD CHARA in the
setup menu is set to “ALL”, information such as timecode,
menu settings, and error messages is superimposed on the
output signals (see page 40).
2 Analog audio signal input/output
section
a AUDIO INPUT (analog audio signal input) 1/3 and
2/4 connectors (XLR 3-pin, female)
These connectors input two channels of analog audio.
You can use the A1 INPUT to A4 INPUT items on the
HOME page of the function menu (see page 88) to assign
the signals input to connectors 1/3 (ANALOG1) and
connectors 2/4 (ANALOG2) to audio channels 1 to 4.
You can set the reference input levels with the setup menu
item AUDIO CONTROL >LEVEL SELECT (the factory
default settings are INPUT: +4 dB, REF LEVEL:
– 20 dB).
b AUDIO OUTPUT (analog audio signal output) 1/3
and 2/4 connectors (XLR 3-pin, male)
These output two channels of analog audio.
For 4-channel audio, you can use the INTERFACE
SELECT >AUDIO OUTPUT item of the setup menu (see
page 103) to select whether to output channels 1 and 2, or
channels 3 and 4 (factory default setting: channels 1 and
2).
You can set the output level with the setup menu item
AUDIO CONTROL >LEVEL SELECT (factory default
setting: +4 dB) (see page 102).
c AUDIO MONITOR connectors (phono jack)
These output audio signals for monitoring.
You can select the channels to monitor with MONI CH and
MONI SEL on page P1 of the function menu (see page 89).
REF VIDEO INPUT COMPOSITE OUTPUT
MONITOR
1 REF VIDEO INPUT connectors
2 COMPOSITE OUTPUT
connectors
3 MONITOR
connector
AUDIO INPUT
1/3 2/4
AUDIO OUTPUT
1/3 2/4
AUDIO MONITOR
R L
1 AUDIO INPUT 1/3 and 2/4 connectors
2 AUDIO OUTPUT 1/3 and 2/4
connectors
3 AUDIO MONITOR
connectors