Sherwood R-963 - Manual (Page 14)

14
ENTERING A SETUP CODE
• This remote control can control up to ten different components.
• Before operating audio and video components using the remote control supplied with this receiver, the setup
code for each component should be entered.
• For system remote control operation, the setup code for each Sherwood component such as CD player, tape
deck and DVD player(V-756, etc.) is “001” respectively. (However, the setup code for some Sherwood DVD
player such as VD-4103, etc. is “112”, ”114” or “091”. Enter each setup code for CD player and tape deck doing
from step
as follows.
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET
VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500
ROOM 2
ENT
MAIN
POWER
OFF
OSD POWER
OFF
OSD
Select the device from which the appropriate
3 digit setup code table will be selected.
Example) If it is the AUDIO code table,
select the AUDIO.
6
Example) The 3 digit setup codes for the Sherwood
“Audio” are 001,024, ...(Hint:The correct
setup code for this receiver is “001”.)
Find the setup code for your component
referring to “Set-Up Code Table” in the
operating manual of this remote control.
2
Turn on the component you want to control.
1
Example) When entering the setup code for this
receiver, turn on this receiver.
Note:
If you component has the discrete POWER ON and OFF
buttons, please do not turn on the component manually.
POWER
OFF
OSD
Select the Pre-PROgramming mode.
4
Press both the MAIN and ROOM 2(/ENTER)
buttons simultaneously for 3 seconds.
3
Then the Pre-PROgramming menu will be displayed. Then the setup menu will be displayed on the LCD
screen.
Note:
If the display of the corresponding mode disappears,
start again from the above step
or the current mode.
5
Select the device corresponding to the
component you want to control.
Example) When selecting the AUDIO for
receiver or amplifier, etc.
ENGLISH