Sherwood R-963 - Manual (Page 29)

ENGLISH
29
Repeat the above steps to to
memorize other stations.
4
After selecting the tuner as input source,
select the preset tuning mode.
1
When using the NUMERIC buttons on the remote
control.
Examples)
For “3” :
For “15” :
For “30” :
The station has now been stored in the memory.
When using the NUMERIC buttons, the station is stored
automatically without pressing the MEMORY/ ENTER
button.
A stored frequency is erased from the memory by storing
another frequency in its place.
If “MEMO” goes off, start again from the above step
.
Then “PRESET” lights up.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned
off, are memorized.
INPUT SELECTOR settings
Surround mode settings
Preset stations, etc.
Note : If the electricity fails or the AC input cord is
disconnected for about 2 weeks, all
memorized settings will be lost.
When using the NUMERIC buttons on the remote
control.
Examples)
For “3”:
For “15”:
For “30”:
When selecting the desired preset number with the
NUMERIC buttons, the desired preset station will be
tuned to automatically without selecting the preset
tuning mode.
Tuning to preset stations
The receiver will start scanning the stations in the
preset sequence and each station is received for 5
seconds.
At the desired station, press this button again to
stop scanning.
Scanning preset stations in sequence
Select the desired preset number.
2
Select the desired preset number(1~30)
and press the MEMORY/ENTER button.
3
TUNING/PRESET
(or )
within 2 seconds
within 2 seconds
3
1 5
0 0 3
within 2 seconds
3
1 5
0
MEMO/ENTER TUNING/PRESET
T/P MODE
POWER
OFF
OSD