Sherwood R-963 - Manual (Page 33)

ENGLISH
33
Select the desired video input source to
enter its label.
1
Press the VIDEO LABEL button to enter the
video label mode.
Example) When selecting VIDEO 1.
2
Select the character on the flickering digit.
3
Confirm your selection.
4
Repeat the above steps and to enter
the desired characters on the rest of the
digits.
5
Memorize the desired video label.
6
Entering a video label
Select the desired video input source to be
rectified or cleared.
1
Repeat the steps ~ in “Entering a
video label” procedure.
2
Correcting or clearing a video label
Each time the MULTI CONTROL knob is rotated,
the characters change as follows:
Blank ( )
Alphabets: A~Z, a~z
Numerals: 0~9
Symbols:
This function can be operated only on video input
sources such as VIDEO 1~5.
Then the next digit will flicker.
On up to 9 digits, the desired characters can be entered.
Note: If any button such as “AUDIO”, “VIDEO”, “7.1
CH DIRECT” button, etc. is pressed while
entering a video label, the video label mode will
be canceled.
To clear a video label, make a blank on each digit
and memorize it, then the video label is cleared and
its factory video input source will be displayed.
If the VIDEO LABEL button is pressed for more
than 3 seconds, blanks will be made on all the digits
at once.
or
VIDEO
POWER
OFF
OSD
or
VIDEO
POWER
OFF
OSD
MULTI CONTROL
VIDEO LABEL
VIDEO LABEL
MEMO/ENTER