English – Sherwood R-963 User Manual
Page 15
15
The code is saved and the Pre-PROgramming mode
is resumed.
When you do not want to save the code, select the
EXIT on the LCD screen or press the MAIN button.
Confirm that it is the right code by pressing
the POWER button and then save the code.
8
Enter the 3 digit setup code aiming the
remote control at the REMOTE SENSOR on
the component.
7
Your component will be turned off when the right
code is entered.
Continue to enter the corresponding codes until your
component turns off.
Operate the component using the
corresponding function buttons.
10
To resume the MAIN menu mode, press the
MAIN button twice briefly.
9
Each time the MAIN button is pressed, the previous
mode is resumed.
If any of the buttons fails to operate as they should,
start from the step
again to enter the next setup code.
Notes:
If the Manufacturer/Brand for your component is not
listed in “Set-Up Code Table” in the operating manual
of this remote control, please use the “ 2 Auto Scan
Method” on page 13 in the operating manual of this
remote control.
Although each setup code is designed to work with
many different modes, certain codes may not work with
some models.( Also, certain codes may only operate
some of the functions available on a given model.)
Repeat the above steps
to
for each of your other components.
11
ENGLISH
OFF
OSD
POWER
MAIN
PAGE
FAV
MUTE
CH/
SET
VOL
RETURN
DISC
DISP
MI
ROOM 2
1
STEREO
7.1
SURR
CH
2
3
4
5
6
7
8
9
0
ENT
M2
M3
AUTO
DSP
RNC-500
For "001" :
For "102" :
0
0
1
1
0
2
OFF
OSD
POWER
MAIN
PAGE
FAV
MUTE
CH/
SET
VOL
RETURN
DISC
DISP
MI
ROOM 2
1
STEREO
7.1
SURR
CH
2
3
4
5
6
7
8
9
0
ENT
M2
M3
AUTO
DSP
RNC-500
MAIN
The selected device
POWER
OFF
OSD