Sherwood R-963 - Manual (Page 35)

ENGLISH
35
Using the OSD
CURRENT STATUS DISPLAY
This mode shows the status corresponding to each operation.
The on-screen display will automatically disappear in 5 seconds.
For examples, there are 2 status displays as follows.
Note :
When watching a movie earnestly, if you want to turn off the current status display function, set the
OSD mode to Off.(For details, refer to “When selecting the OSD MODE” on page 44.)
When selecting the desired input source. When selecting the TEST TONE mode.
This unit incorporates an OSD(On-screen display) function to provide information about basic operation of this unit and to
simplify the setup procedures.
The OSD function uses a monitor TV connected to this unit as a display and has two kinds of display modes such as current
status display and menu screen.
Notes: The OSD function is not available via the component video connection.
Any on-screen display shown on the monitor TV will not be recorded onto VIDEO 1.
The OSD menu allows you to perform the setup procedures easily. In most situations, you will only need to set this
once during the installation and layout of your home theater, and it rarely needs to be changed later. The OSD
menu consists of 6 main menus: power amp assign, speaker setup, function select, surround setup, CH level trim
and room 2 feed setup. Some of these menus are divided up into various sub-menus.
The OSD menu settings are performed easily with the CURSOR control(
, , , ), ON-SCREEN DISPLAY,
RETURN and ENTER buttons.
The “3”, “7”, “8” and “9” of the NUMERIC buttons do also work as the CURSOR control(
, , , )buttons do. In
this case, the “3” button stands for the CURSOR UP( ) button, the “7” for the CURSOR LEFT( ), the “8” for the
CURSOR DOWN( ) and the “9” for the CURSOR RIGHT( ).
VIDEO 1 (OPTICAL1)
Input source Signal input Channel level or overall volume display
FL : - - - - - - - - - - - - : 0 dB
The main menu will be shown.
To turn the menu screen off, press this button again.
In the bottom of the display, “OSD” stands for the ON-
SCREEN DISPLAY button, “RETURN” for “RETURN”,
“ENTER” for “ENTER”, “
”, “ ”, “ ” and “ ” for
CURSOR UP( ), DOWN( ), LEFT( ) and RIGHT( ).
OFF
OSD POWER
MAIN PAGE FAV
MUTE
CH/ SET VOL
RETURN
DISC DISP
MI
ROOM 2
1 STEREO
7.1 SURR
CH
2 3
4 5 6
7 8 9
0 ENT
M2 M3
AUTO DSP
RNC-500
OFF
OSD
M A I N M E N U
O S D : Q u i t E N T E R : S e l e c t
P O W E R A M P A S S I G N
S P E A K E R S E T U P
F U N C T I O N S E L E C T
S U R R O U N D S E T U P
C H L E V E L T R I M
R O O M 2 F E E D S E T U P
When adjusting each channel level or overall volume, the volume
level display will be shown.
The test tone display will be shown until the test tone mode is
canceled.
Turn the menu screen on.
1
OSD Menu Settings