Siemens E-110-I - Manual (Page 42)

SIEMENS ADSL E-110_E-110-I user manual
Quick Configuration
The Quick Configuration displays the settings you are most likely to need to change when you first set up
your ADSL Router. Work with your ISP to determine the values or settings you need to change.
Select Home > Quick Configuration. The
Quick Configuration page displays.
The Quick Configuration page contains the following fields:
Field Description
ATM Interface Select the ATM interface you want to use (usually atm-0)
Operation Mode Enables or disables the device’s Internet and routing function. When set to
Disabled, the device cannot be used to provide Internet connectivity for your
network.
Encapsulation Determines the type of data link used to communicate with your ISP.
VPI / VCI Enter the VPI/VCI values given by your ISP, e.g. 0 / 35
Bridge Enables or disables bridging between the device and your ISP.
IGMP Enables or disables the Internet Group Management Protocol, which some
ISPs use to perform remote configuration of your device.
IP Address Enter the IP address given by your ISP, e.g. 10.100.17.89.
Subnet Mask Enter the associated subnet mask given by your ISP, e.g. 255.255.255.248.
Default Route When enabled, it specifies that the IP address entered above will be used as
the default route for your LAN.
Gateway IP Address Specifies the IP address that identifies the ISP server through which your
Internet connection will be routed. Enter the IP Address given by your ISP,
e.g. 10.100.17.94.
Username / Password Enter the username and password you use to log in to your ISP.
Note: This is not the same as the username and password you used to log in
to Configuration Manager.
36 Rev:01_040220