Siemens E-110-I - Manual (Page 79)

Chapter 5: Connection Mode
5. When confirmation page appears, click [Close].
6. You will return to the
ATM(EoA) Config page and see the newly added EoA entry.
3. Enable Bridging function.
1. Select Bridge > Bridging to display the Bridge Configuration page.
2. Select eth-0 from the list and click [Add].
3. Select the EoA interface to be used (e.g. eoa-0) from the drop-down list, and then click [Add].
4. Make sure Enable is selected for Bridging.
5. Click [Apply]. A page gives a receipt for the changes.
4. LAN configuration.
1. Select Bridge > LAN Config.
2. Don’t modify the settings; just keep the default shown as the figure below:
Rev:01_040220 73