Siemens E-110-I - Manual (Page 78)

SIEMENS ADSL E-110_E-110-I user manual
3. Enter the provided fields as below.
Field Description
VC Interface Select a VCC interface from the available interfaces, e.g. aal5-1.
VPI / VCI Enter the VPI/VCI values given by your ISP, e.g. 0 / 33.
Mux Type Select LLC or VC as required by your ISP.
Max Proto per AAL5 Keep the default 2.
4. After entering the fields above, click [Apply].
5. When confirmation page appears, click [Close].
6. You will return to the
ATM VC Configuration page and see the newly added ATM VC entry.
2. Creating an EoA interface.
1. Select Bridge > RFC1483 Interface (EoA).
2. On the ATM(EoA) Config page click [Add] to add a new EoA interface.
3. Enter the provided fields as below:
Field Description
EOA Interface Select an EoA interface from the available interfaces, e.g. eoa-1.
Interface Sec Type Select Public.
Lower Interface Select the ATM VCC interface you created, e.g. aal5-1.
Conf. IP Address /
Netmask 0.0.0.0 / 0.0.0.0.
To use the device as a bridge, you don’t need to set the IP address and
subnet mask. Just keep the default.
Use DHCP Select Disable
Default Route Select Disable
Gateway IP Address Leave it empty. You don’t need to set the gateway.
4. After entering the fields above, click [Apply].
72 Rev:01_040220