Siemens E-110-I - Manual (Page 83)

Chapter 5: Connection Mode
Router Connection Mode
In this deployment environment, we make up a private IP network of 192.168.1.1. NAT function is enabled
(on ADSL Router or use another NAT box connected to hub) to support multiple clients to access the
Router and some public servers (WWW, FTP).
If you apply for multiple IP addresses from your ISP, you can assign these public IP addresses to the ADSL
Router and public server, e.g., Web or FTP server. Typically the first IP is network address, the second is
used as router IP address and the last one is subnet broadcasting. Other remaining IP addresses can be
assigned to PCs on the LAN.
This section describes both RFC1577 and 1483 Bridge connection methods.
Part 1: Configuring the ADSL Router
1. Creating an ATM VCC interface.
1. Select Wan > ATM VC.
2. On the ATM VC Configuration page click [Add] to add a new ATM VCC interface.
3. Enter the provided fields as below:
Field Description
VC Interface Select a VCC interface from the available interfaces, e.g. aal5-2.
VPI / VCI Enter the VPI/VCI values given by your ISP, e.g. 0 / 34.
Mux Type Select LLC or VC as required by your ISP.
Max Proto per AAL5 Keep the default 2.
4. After entering the fields above, click [Apply].
5. When confirmation page appears, click [Close].
6. You will return to the
ATM VC Configuration page and see the newly added ATM VC entry.
Rev:01_040220 77