Siemens E-110-I - Manual (Page 70)

SIEMENS ADSL E-110_E-110-I user manual
Managing Current IP Filter Sessions
1. Select Services > IP Filter. The IP Filter Configuration page displays.
2. To view all current IP sessions, click [Session]. The IP Filters Session page displays.
It displays the following fields:
Field Description
Session Index The ID assigned by the system to the IP session (all sessions, whether or not they
are affected by an IP filter rule, are assigned a session index).
Time to expire The number of seconds in which the connection will automatically expire
Protocol The underlying IP protocol used on the connection, such as TCP, UDP, IGMP,
etc.)
I/F The interface on which the IP Filter rule is effective
IP Address The IP addresses involved in the communication. The first one shown is the
initiator of the communication.
Port The hardware addresses of the ports involved in the communication
In/Out Rule Index The number of the IP Filter rule that is applies to this session (assigned when the
rule was created)
In/Out Action The action (accept, deny, or unknown), being taken on data coming into or
going out on the interface. This action is specified in the rule definition.
To Block Specific Protocols
1. To block specific protocols running across the system, select Services > Blocked Protocols.
2. Check the protocol type you want to block
3. Click
[Apply].
4. Select Admin > Commit & Reboot and click [Save] to save your changes to permanent storage.
To unblock the specific protocol, uncheck the protocol and repeat the submit and commit task.
64 Rev:01_040220