Sony HDW-S280 - Manual (Page 22)

22
Preparing Power Sources
Chapt
er
3
P
rep
ar
at
ions
Chapter
3
Preparations
3-1 Preparing Power
Sources
This unit can be powered by AC power, DC power, or a
battery pack.
If you load or remove a battery pack incorrectly, it may fall
and cause bodily injury. Follow the procedures described
below to load or remove them.
3-1-1 Supplying Power
This unit has two power switches, one on the front panel
and another on the rear panel. The power switch on the
front panel is to turn DC power ON/OFF, and the POWER
switch on the rear panel is to turn AC power ON/OFF.
Power is supplied to the unit in combination of these two
switches as shown below. When AC power is switched on,
the AC power indicator lights on the front panel. When
DC power is switched on, a battery mark appears in the
display window on the front panel.
AC power supply
Connect the AC IN connector to an AC power source
using the specified AC power cord. To supply AC power
to the unit, set the power switch on the front panel to ?
(ON) and the POWER switch on the rear panel to ON.
DC power supply
Connect the DC IN 12V connector to a DC power source.
To supply DC power to the unit, set the power switch on
the front panel to ? (ON) and the POWER switch on the
rear panel to OFF. If the POWER switch on the rear panel
is set to ON, AC power is supplied.
Battery power supply
Charge a battery pack beforehand using the BC-L100
Battery Charger. The BP-GL65 is fully charged for about
2.5 hours and the BP-GL95 is fully charged for about 3.5
hours. Using the fully-charged BP-GL95, continuous
recording of up to 80 minutes is possible.
For details on charging battery packs, refer to the
operation manual for the BC-L100.
Applicable battery packs
Battery packs that can be used with this unit are as follows.
To use battery pack, a BKP-L551 Battery Adaptor and a
BC-L100 Battery Charger are required.
• BP-L60(A)/L90(A)
• BP-GL65/GL95
• BP-M50/M100
Notes about battery usage
• Before using the batteries, be sure to charge them fully
with the special battery charger. Refer to the operating
instructions for your battery charger for more
information about how to charge the batteries.
• Batteries may not be completely charged if you charge
them immediately after use when they are still warm.
You should wait until the batteries cool before charging
them.
Note
Power switch on the front panel
? (ON) 1 (OFF)
POWER
switch
on the
rear
panel ON AC power supply
AC indicator lit No power supply
AC indicator lit
OFF DC power supply
AC indicator not lit No power supply
AC indicator not lit