Sony HDW-S280 - Manual (Page 74)

74
Items in the Extended Setup Menu
Chap
ter
9
Set
up Men
u
s
710 INTERNAL VIDEO SIGNAL
GENERATOR Select the test signal to be generated by the internal test signal generator.
OFF: No test signal is generated. (The VTR operates normally.)
[CB75]: Color bar signal
MLTBS: Multi-burst signal
10STEP: 10-step signal
PLSBR: Pulse and bar signal
RAMP: Ramp signal
BLACK: Black signal
MCB: Multi color bar signal
To generate the test signal, set this item other than OFF, and press the VIDEO IN
function button for more than three seconds on the P2 VIDEO page of the function
menu. VIDEO IN is set to SG, and a test signal is generated. Pressing the VIDEO IN
function button again stops the generation of a test signal.
713 VIDEO SETUP
REFERENCE LEVEL (in
59.94i/29.97PsF mode
only) Set the video setup amount to be removed from the Betacam playback signal and to be
added to the composite output signal.
Sub-Item
0 MASTER LEVEL When BETACAM PB LEVEL and OUTPUT LEVEL is set to MASTER, the setup
amount selected with this item is removed from the Betacam playback signal and
added the same amount to the output signal.
[0.0%], 7.5%
1 BETACAM PB LEVEL [MASTER]: Set the Betacam playback signal to master.
0.0%, 7.5%: Set the setup amount to be removed from the Betacam playback signal.
2 OUTPUT LEVEL [MASTER]: Set the output signal to master.
0.0%, 7.5%: Set the setup amount to be added to the output signal.
715
a) VIDEO GAIN CONTROL Adjust the video output level of an SD output signal.
0 to [800H] to B50H
716
a) CHROMA GAIN CONTROL Adjust the chroma output level of an SD output signal.
0 to [800H] to B50H
717
a) CHROMA PHASE
CONTROL Adjust the chroma phase of an SD output signal.
0 to [80H] to FFH
718 a) SETUP LEVEL Adjust the SD setup level (black level) of an SD output signal.
0 to [110H] to 220H
719 a) SYSTEM PHASE SYNC Adjust the sync phase of an SD output signal.
0 to [80H] to FFH
720
a) SYSTEM PHASE SC Adjust the subcarrier phase of an SD output signal.
[0] to 3FFH
721
a) Y/C DELAY For playback of an analog Betacam cassette, adjust the Y/C delay.
0 to [800H] to FFFH
726
a) H BLANKING WIDTH Select the horizontal blanking width of the video output signal.
[NARROW]: Digital blanking (narrow)
WIDE: Analog blanking (wide)
When WIDE is selected, the horizontal blanking width complies with RS170A, and
normally the blanking is widened and the image becomes narrower. It is recommended
to select NARROW at the editing stage, then later, for broadcast transmission to select
WIDE, to output a signal conforming to the standard.
727 VIDEO EDIT PREVIEW
SWITCHER Set the output phase for the video playback signal when ASSEMBLE on the HOME
page of the function menu is set to ON.
[INT]: The output phase of the video playback signal is the same as the output phase in
E-E mode. Use this setting when editing with a single VTR, or when previewing
while watching the VTR output signal.
EXT: The output phase of the video playback signal is the same as the phase of an
input video signal or external reference signal.
728 OUTPUT SCH PHASE Adjust the subcarrier H phase.
0 to [800H] to FFFH
Item
number Item name Settings