SMC Networks SMC2552W-G2-17 - Manual (Page 177)

Command Line Interface
7-40
7
SNMP Commands
Controls access to this access point from management stations using the Simple
Network Management Protocol (SNMP), as well as the hosts that will receive trap
messages.
Table 7-9. SNMP Commands
Command Function Mode Page
snmp-server community Sets up the community access string to permit access
to SNMP commands
GC 7-42
snmp-server contact Sets the system contact string GC 7-42
snmp-server location Sets the system location string GC 7-43
snmp-server enable server Enables SNMP service and traps GC 7-43
snmp-server host Specifies the recipient of an SNMP notification
operation
GC 7-44
snmp-server trap Enables specific SNMP notifications GC 7-45
snmp-server engine id Sets the engine ID for SNMP v3 GC 7-47
snmp-server user Sets the name of the SNMP v3 user GC 7-47
snmp-server targets Configures SNMP v3 notification targets GC 7-49
snmp-server filter Configures SNMP v3 notification filters GC 7-50
snmp-server
filter-assignments
Assigns SNMP v3 notification filters to targets GC 7-51
show snmp groups Displays the pre-defined SNMP v3 groups Exec 7-51
show snmp users Displays SNMP v3 user settings Exec 7-52
show snmp
group-assignments
Displays the assignment of users to SNMP v3 groups Exec 7-52
show snmp target Displays the SNMP v3 notification targets Exec 7-53
show snmp filter Displays the SNMP v3 notification filters Exec 7-53
show snmp
filter-assignments
Displays the SNMP v3 notification filter assignments Exec 7-54
show snmp Displays the status of SNMP communications Exec 7-55