SMC Networks SMC2552W-G2-17 - Manual (Page 26)

Features and Benefits
1-5
1
Reset Button
This button is used to reset the access point or restore the factory default
configuration. If you hold down the button for less than 5 seconds, the access point
will perform a hardware reset. If you hold down the button for 5 seconds or more,
any configuration changes you may have made are removed, and the factory default
configuration is restored to the access point.
Power Connector
The access point does not have a power switch. It is powered on when connected to
the AC power adapter, and the power adapter is connected to a power source. The
power adapter automatically adjusts to any voltage between 100-240 volts at 50 or
60 Hz. No voltage range settings are required.
The access point may also receive Power over Ethernet (PoE) from a switch or
other network device that supplies power over the network cable based on the IEEE
802.3af standard.
Note that if the access point is connected to a PoE source device and also
connected to a local power source through the AC power adapter, PoE will be
disabled.
Features and Benefits
• Local network connection via 10/100 Mbps Ethernet ports or 54 Mbps wireless
interface (supporting up to 128 mobile users)
• IEEE 802.11b, and 802.11g compliant
• Interoperable with multiple vendors based on the IEEE 802.11f protocol
• Advanced security through 64/128/152-bit Wired Equivalent Protection (WEP)
encryption, IEEE 802.1X authentication via a RADIUS server, Wi-Fi Protected
Access (WPA), and MAC address filtering features to protect your sensitive data
and authenticate only authorized users to your network
• Provides seamless roaming within the IEEE 802.11b and 802.11g WLAN
environment
• Scans all available channels and selects the best channel for each client based on
the signal-to-noise ratio
• Allows the country of operation to be set to match regulatory requirements (for
countries outside of the United States)