SMC Networks SMC2552W-G2-17 - Manual (Page 275)

Cables and Pinouts
B-2
B
Straight-Through Wiring
Because the 10/100 Mbps port on the access point uses an MDI pin configuration,
you must use “straight-through” cable for network connections to hubs or switches
that only have MDI-X ports. However, if the device to which you are connecting
supports auto-MDIX operation, you can use either “straight-through” or “crossover”
cable.
Table B-1. 10/100BASE-TX MDI Port Pinouts
Pin MDI Signal Name
1 Transmit Data plus (TD+)
2 Transmit Data minus (TD-)
3 Receive Data plus (RD+)
4 GND (Positive Vport)
5 GND (Positive Vport)
6 Receive Data minus (RD-)
7 -48V feeding power (Negative- Vport)
8 -48V feeding power (Negative- Vport)
Note: The “+” and “-” signs represent the polarity of the wires that
make up each wire pair.
White/Orange Stripe
Orange
White/Green Stripe
Green
1
2
3
4
5
6
7
8 1
2
3
4
5
6
7
8
EIA/TIA 568B RJ-45 Wiring Standard
10/100BASE-TX Straight-through Cable
End A End B
Blue
White/Blue Stripe
Brown
White/Brown Stripe