SMC Networks SMC2552W-G2-17 - Manual (Page 36)

Installation Procedures
3-3
3
To connect pigtail cables to the access point, follow these steps:
1. Disable the access point radio using the web browser interface, CLI, or SNMP.
2. Remove power to the access point.
3. Remove both of the access point’s antennas by unscrewing them at their base.
4. For diversity antennas, connect the antenna pigtail cables to the exposed
Reverse SMA connectors on both sides of the access point.
For non-diversity antennas, be sure to connect the single pigtail cable to the
Reverse SMA connector on the access point’s side activated through the
software interface.
Unscrew
antenna to
remove
Antenna pigtail
cable
Screw onto access point’s
Reverse SMA connector