SMC Networks SMC2552W-G2-17 - Manual (Page 181)

Command Line Interface
7-44
7
Command Usage
The snmp-server host command is used in conjunction with the
snmp-server enable server
command to enable SNMP notifications.
Example
Related Commands
snmp-server enable server (7-43)
snmp-server trap
This command enables the access point to send specific SNMP traps
(i.e., notifications). Use the no form to disable specific trap messages.
Syntax
snmp-server trap
<trap>
no snmp-server trap
<trap>
• trap - One of the following SNMP trap messages:
- sysSystemUp - The access point is up and running.
- sysSystemDown - The access point is about to shutdown and reboot.
- sysRadiusServerChanged - The access point has changed from the
primary RADIUS server to the secondary, or from the secondary to the
primary.
- sysConfigFileVersionChanged - The access point’s configuration file
has been changed.
- dot11StationAssociation - A client station has successfully associated
with the access point.
- dot11StationReAssociation - A client station has successfully
re-associated with the access point.
- dot11StationAuthentication - A client station has been successfully
authenticated.
- dot11StationRequestFail - A client station has failed association,
re-association, or authentication.
- dot11InterfaceBFail - The 802.11b interface has failed.
- dot1xMacAddrAuthSuccess - A client station has successfully
authenticated its MAC address with the RADIUS server.
- dot1xMacAddrAuthFail - A client station has failed MAC address
authentication with the RADIUS server.
- dot1xAuthNotInitiated - A client station did not initiate 802.1X
authentication.
- dot1xAuthSuccess - A 802.1X client station has been successfully
authenticated by the RADIUS server.
Enterprise AP(config)#snmp-server host 1 10.1.19.23 batman
Enterprise AP(config)#