SMC Networks SMC2552W-G2-17 - Manual (Page 238)

Wireless Interface Commands
7-101
7
Example
antenna location
This command selects the antenna mounting location for the radio interface.
Syntax
antenna location <indoor | outdoor>
• indoor - The antenna is mounted indoors.
• outdoor - The antenna is mounted outdoors.
Default Setting
Indoor
Command Mode
Interface Configuration (Wireless)
Command Usage
• When an external antenna is selected, the antenna control must be set to
“right.”
• Selecting the correct location ensures that the access point only uses radio
channels that are permitted in the country of operation.
Example
beacon-interval
This command configures the rate at which beacon signals are transmitted from the
access point.
Syntax
beacon-interval
<interval>
interval
- The rate for transmitting beacon signals.
(Range: 20-1000 milliseconds)
Default Setting
100
Command Mode
Interface Configuration (Wireless)
Command Usage
Enterprise AP(if-wireless g)#antenna id 0000
Enterprise AP(if-wireless g)#
Enterprise AP(if-wireless g)#antenna location indoor
Enterprise AP(if-wireless g)#