Link integrity commands – SMC Networks SMC2552W-G2-17 User Manual
Page 260
Link Integrity Commands
7-123
7
known to be already authenticated, so it proceeds directly to key exchange
and association.
• To support pre-authentication, both clients and access points in the network
must be WPA2 enabled.
• Pre-authentication requires all access points in the network to be on the
same IP subnet.
Example
Link Integrity Commands
The access point provides a link integrity feature that can be used to ensure that
wireless clients are connected to resources on the wired network. The access point
does this by periodically sending Ping messages to a host device in the wired
Ethernet network. If the access point detects that the connection to the host has
failed, it disables the radio interfaces, forcing clients to find and associate with
another access point. When the connection to the host is restored, the access point
re-enables the radio interfaces.
Enterprise AP(if-wireless g: VAP[0])#wpa-pre-shared-key ASCII agoodsecret
Enterprise AP(if-wireless g: VAP[0])#
Table 7-20. Link Integrity Commands
Command
Function
Mode
Page
link-integrity ping-detect
Enables link integrity detection
GC
link-integrity ping-host
Specifies the IP address of a host device in the
wired network
GC
link-integrity ping-interval
Specifies the time between each Ping sent to the
link host
GC
link-integrity ping-fail-retry
Specifies the number of consecutive failed Ping
counts before the link is determined as lost
GC
link-integrity ethernet-detect
Enables integrity check for Ethernet link
GC
show link-integrity
Displays the current link integrity configuration
Exec