SUPER MICRO Computer X7SBL-LN1/LN2 - Manual (Page 25)

Chapter 2: Installation
2-7
2-4 Installing DIMMs
Note: Check the Supermicro web site for recommended memory modules.
Warning: Exercise extreme care when installing or removing
DIMM modules to prevent any possible damage. Also note that
the memory is interleaved to improve performance (see step
1).
DIMM Installation
Insert the desired number of DIMMs into the memory slots, starting with 1.
DIMM1A. The memory scheme is interleaved so you must install two modules
at a time, beginning with DIMM1A, DIMM1B, then, DIMM2A and DIMM2B
Insert each DIMM module vertically into its slot. Pay attention to the notch 2.
along the bottom of the module to prevent inserting the DIMM module incor-
rectly.
Gently press down on the DIMM module until it snaps into place in the slot. 3.
Repeat for all modules (see step 1 above).
Memory Support
The X7SBL-LN1/LN2 supports up to 8 GB Unbuffered ECC or non-ECC DDR2
800/677 MHz in 4 DIMMs. Populating DIMM#1A, DIMM#1B, and/or DIMM#2A,
DIMM#2B with memory modules of the same size and of the same type will result
in dual channel, two-way interleaved memory which is faster than the single chan-
nel, non-interleaved memory.
Notes:
Due to the OS limitations, some operating systems may not show more than 1.
4GB of memory.
Both Unbuffered ECC and Non-ECC memory modules can be installed in the 2.
memory slots.
Due to memory allocation to system devices, memory remaining available for 3.
operational use will be reduced when 4 GB of RAM is used. The reduction in
memory availability is disproportional. (Refer to the following Memory Avail-
ability Table for details.)
!