SUPER MICRO Computer X7SBL-LN1/LN2 - Manual (Page 26)

2-8
X7SBL-LN1/LN2 User’s Manual
To Install: Insert module vertically and press down until it
snaps into place. Pay attention to the alignment notch at the
bottom.
Installing and Removing DIMMs
To Remove:
Use your thumbs
to gently push
the release tabs
near both ends of
the module. This
should release it
from the slot.
Top View of DDR2
Possible System Memory Allocation & Availability
System Device Size Physical Memory
Remaining (-Available)
(4 GB Total System Memory)
Firmware Hub fl ash memory (System
BIOS) 1 MB 3.99
Local APIC 4 KB 3.99
Area Reserved for the chipset 2 MB 3.99
I/O APIC (4 Kbytes) 4 KB 3.99
PCI Enumeration Area 1 256 MB 3.76
PCI Express (256 MB) 256 MB 3.51
PCI Enumeration Area 2 (if needed)
-Aligned on 256-MB boundary- 512 MB 3.01
VGA Memory 16 MB 2.85
TSEG 1 MB 2.84
Memory available to OS and other ap-
plications 2.84
Top View of DDR2 Slot
Note: Notch
should align
with the
receptive point
on the slot
Notch Notch
Release
Tab
Release
Tab
DDR2 DIMM