SIGMA SD10 - Manual (Page 75)

75
OVER-EXPOSURE WARNING
Highlight areas of an image where detail may be lost due to over-exposure will be
indicated by a solid red overlay when Exposure Warning is set to On in the Camera
Set-up Menu. The over-exposure overlay will be visible in the all views except for
Contact Sheet and Jump Mode. The over-exposure overlay will also be hidden
during a slideshow.
TO TURN OFF OVER-EXPOSURE WARNING
1
Make sure the camera is turned on.
2
Press the ＜ MENU＞ button on the back of
the camera to display the Camera Set-up Menu.
(See P.96)
3
Use ＜ ／ ＞ arrows on the 4-way
controller to select “Exposure Warning”.
4
Press ＜
＞ arrow or ＜ OK ＞ to open
sub-menu.
5
Use ＜ ／ ＞ arrows on the 4-way
controller to select “Off”.
6
Press ＜ ＞ arrow or ＜ OK＞ to apply the
setting or ＜ ＞ arrow or ＜
CANCEL＞
to close the sub-menu without making any
changes.
TIP
•
The ＜ OK＞ button can be used as a shortcut key to temporarily toggle the
over-exposure warning overlay on or off. Using the shortcut key will not change
the Exposure Warning setting in the Set-up Menu. (See P.90 to set OK key
shortcut.)