Sony STORSTATION LIB-D81 - Manual (Page 20)

20
Chapter 2 Installation
2 MAINTENANCE (on)
0: Warning messages are not displayed when specific parts reach the end of
their service life or when in need of cleaning (weekly).
1: Warning messages are displayed when specific parts reach the end of their
service life or when in need of cleaning (weekly).
3 LOADER SEL (off)
0: The autoloader option function is not active.
1: The autoloader option function is active.
When this setting is active, the AIT autoloader monitors the AIT drive
status on a regular basis, as well as perform the following.
- When a cartridge is unloaded, it is automatically ejected and returned to
its original slot, and the cartridge from the next slot is inserted into the
AIT drive.
- When the cleaning cartridge is in the AIT drive and cleaning ends, the
cleaning cartridge is automatically ejected and returned to its original
slot, and the cartridge from the next slot is inserted into the AIT drive.
4 CONTINUOUS (off)
0: The autoloader option function is not in continuous mode.
1: The autoloader option function is in continuous mode.
You can use this setting only if LOADER SEL in set to “1”. When you
activate this setting and the autoloader option function returns a cartridge
to slot CL/8 (the last slot), it automatically inserts the cartridge from the
newest slot into the AIT drive.
5 AUTOLOAD (off)
0: The autoloader option function is not in automatic loading mode.
1: The autoloader option function is in automatic loading mode.
You can use this setting only if LOADER SEL in set to “1”. When you
activate this setting and turn on the AIT autoloader, the AIT autoloader
automatically inserts the cartridge from the newest slot in the AIT drive.
6 RMIC (off)
This function is not supported.
7 RESERVED (off)
Extension. Do not use.
8 RESERVED (off)
Extension. Do not use.
1
Make sure that the power switch on the rear of the AIT autoloader is in the
off position (a is depressed).
2
Use a pointed object such as a machinist’s screwdriver to change the
settings of the DIP switches.
3
Press the power switch to turn on the power.
If you change the SCSI ID settings or connect SCSI peripheral devices, do
not turn on the power from here. Instead, see “Setting the SCSI ID” (page
21) and “Connecting SCSI Peripheral Devices” (page 22).