Sony STORSTATION LIB-D81 - Manual (Page 54)

54
Appendix
Notes
1 To begin cleaning the AIT drive, insert the cleaning cartridge in slot CL/8 and
press the CLEAN button for at least three seconds.
2 If you are unable to open the front door, it may be locked from your backup
software.
3 If the cartridge is not ejected from the AIT drive when an error occurs,
proceed as follows.
1 Press the DOOR button for at least five seconds.
The cartridge is forcibly ejected from the AIT drive and the front
door unlocked.
2 Restart the system.
3 Restart the AIT autoloader.
4 If [ ] appears to be rotating or [E J] flashes on the display, then the loader is
in operation. Depending on the state of the cartridge, it may take up to 20
minutes for it to be detected.
5 Pressing the CLEAN and DOOR buttons simultaneously for at least five
seconds starts Disaster recovery.
6 In the code reference table, “XX” refers to an error code.
7 Cleaning normally takes approximately one minute. If there is a cartridge in
the AIT drive when you begin cleaning the drive, it is returned to its original
slot before the cleaning procedure starts.
If you are writing to a damaged cartridge, unloading may take some time. For
this reason, cleaning can take up to 20 minutes.