Sun Microsystems SUN FIRE 280R - Manual (Page 192)

164 Sun Fire 280R Server Owner’s Guide • January 2001
connections and set OpenBoot configuration variables that redirect the console
output to RSC. These tasks are described in “How to Monitor the System Using Sun
Remote System Control (RSC)” on page 175.
The following chart provides an overview of connections enabled after RSC has been
installed and configured.
Remote System Control card ok prompt and/or
Connection from Solaris/PC/ASCII terminal to server with RSC installed
Local Server
Remote Host Connection
the Solaris Operating Environment prompt.
System
boots
?
Run SunVTS
Run POST
yes no
POST
failure
?
yes no
Replace part
Run OpenBoot
Diagnostic
failure
?
yes
no
Software or
disk problem
yes no
LED lit
Fault
?
Diagnostics
no yes
Disk
Run Sun
Management
Center
Software
problem
failure?
Connected to local server ok prompt, or Solaris OS CLI prompt, or RSC GUI.
via telnet or modem.