Press the front panel power button once – Sun Microsystems SUN FIRE 280R User Manual
Page 69
Chapter 2
System Setup
41
2. Turn on power to the local graphics console or ASCII terminal.
A local graphics console or ASCII terminal is required for viewing system messages.
For setup instructions, see “How to Attach an Alphanumeric (ASCII) Terminal” on
page 34 or “How to Configure a Local Graphics Console” on page 36.
3. Turn the front panel keyswitch to the Power-On/Off position.
Insert the system key into the keyswitch. See “Keyswitch Settings” on page 9 for
information about each keyswitch setting.
4. Press the front panel Power button once.
Note –
The system may take anywhere from 30 seconds to several minutes before
video is displayed on the system console or the
ok
prompt appears on an attached
terminal. This time depends on the level of power-on self-test (POST) diagnostics
being performed.
Power button
Power-On/Off position