Sun Microsystems SUN FIRE 280R - Manual (Page 253)

Index 225
types, 19
nvedit command, 189
nvstore command, 189
O
OpenBoot Diagnostics software, 72
OpenBoot firmware, 48
version, 11
OpenBoot PROM variables
boot-device , 48
diag-switch? , 179
operating system software
installing, 19
loading over a network, 59
options, installing, 16
P
parallel port, 3
characteristics, 101
location, 7
pin and signal specifications, 210
parity, 4, 35, 65, 89
parts, shipped to you, 14
PCI (Peripheral Component Interconnect)
buses, 2, 84 to 85
configuration guidelines, 84 to 85
parity protection, 65
slot characteristics, 85
card
configuration guidelines, 84 to 85
device name, 49
frame buffer card, 36
slot characteristics, 85
slot locations, 7, 85
tape drive, 3
types, 2
host adapters, 2
PCI (Peripheral Component Interconnect) See PCI
card, PCI buses
pkgadd utility, 198
pkginfo command, 197
POST (power-on self-test), 72
POST diagnostics
error reporting, 181
how to use, 179
overview, 166
power
LED indicator, 10
turning off, 61
turning on, 40, 44
power cord, AC, when to disconnect, 120
power supply, 6
configuration guidelines, 95
default, 6
display, 6
fault monitoring, 67
hot swap capability, 3, 68, 96
LEDs, 95
output capacity, 95
redundancy, 3, 68, 95
troubleshooting, 195
power-on self-test, See POST diagnostics
pre-POST preparation, verifying baud rate, 185
probe-scsi command, 192, 195
probe-scsi-all command, 194
R
RAID (redundant arrays of independent disks), See
disk configuration
reconfiguration boot, 136
recovery of console, 178
reliability, availability, and serviceability, 64 to 70
reset command, 50
RSC (Remote System Control)
access from the PC, 74
card, 107
described, 74
features, 70, 74, 107
firmware, 12
jumpers, 108
monitoring, 108
ports, 107
software, 12, 110
software features, 110