Siemens 2010 Tango - Manual (Page 26)

Operating modes
16
kap04.fm5 18.7.99 Gigaset 2010, LAM/engl.: A30852-X1100-B313-1-7619
Operating in a telephone system
To be able to operate your Gigaset 2010 Tango in a tele-
phone system, you must first
1. switch off the automatic attenuation function
2. check the signalling method,
3. enter the exchange code,
4. enter the pause lengths after the exchange code.
Activating/deactivating the automatic attenuation function
For operation behind systems, the automatic attenuation
function must be switched off.
Possible signalling method settings
The factory default setting for the signalling method is:
● DTMF/Flash 100 ms
This may have to be changed to operate the device in tel-
ephone systems or in PSTNs in some countries.
B
# 1
Start the setting procedure.
o
Enter the four-digit base code (factory default: “0000“)
(➔ page 19).
O
40 0
B Switch off the automatic attenuation function.
or
O
40 1
B Switch on the automatic attenuation function (for PSTN
connection).
Please also consult the instructions for use sup-
plied with your telephone system.
B
# 1
Start the setting procedure.
o
Enter the four-digit base code (factory default: “0000“)
(➔ page 19).
O
0 3 3 B Set dial pulsing (DP).
or
O
0 3 7
B dual-tone multifrequency signalling DTMF/Flash 100 ms.