Siemens 2010 Tango - Manual (Page 61)

Operation at more than one base station
51
kap17.fm5 18.7.99 Gigaset 2010, LAM/engl.: A30852-X1100-B313-1-7619
Operation at more than one base station
You can register and operate your handset at up to
4 Gigaset Tango base stations.
This offers the following advantages:
● You can operate the same handset at base stations in
different geographical locations (e.g. in the office and at
home).
● You can extend the range or the area in which you can
call with the same handset in large areas by placing
the base stations in suitable locations.
Procedure for operating at more than one base station
We recommend following the procedure below:
1. Register your handset at the required base stations
(➔ page 48) and assign the required base station
numbers (1 to 4).
2. Register your handset at all base stations with the
same internal call number, provided this is not yet
assigned.
A Gigaset Tango handset can only be registered
at Gigaset Tango base stations.
Please note the following when operating at
more than one base station:
● Ongoing calls are interrupted or cleared
down when you move from one base sta-
tion radio range to another.
● Internal calls can only be made within the ra-
dio range of a base station, i.e. not to hand-
sets that are in another base station radio
range.
● If you are out of range of a base station for
several minutes, and your handset is
switched on, then when you re-enter the
range it may take up to 20 minutes to "find"
the base station again. In such cases,
switch the mobile unit off for a brief time
and then on again (➔ page 14). The handset
and base station will "find" each other within
a few seconds.