Sharp FO-DC500 - Manual (Page 194)

Optional Settings
192
Setting 09: ERROR CORRECTION MODE (ECM)
Select YES to have any distortions in a transmission due to noise on the
telephone line corrected before print-out at the receiving end. This is only
effective when the other machine has ECM as well. Select NO to turn the
function off. Press or to make the selection and then press .
Note: If the transmission or reception is taking place in Super G3 mode, ECM
will operate regardless of the ECM setting.
♦
Initial setting: YES
Setting 10: AUTO COVER SHEET
Select YES to have the fax automatically generate a cover sheet and send it
as the last page of each transmission. Select NO to turn the function off.
Press or to make the selection and then press .
♦
Initial setting: NO
Setting 11: FAX SCANNING WIDTH
This setting selects the maximum scanning width. Press or to
select 10 inches or 8.3 inches, and then press .
♦
Initial setting: 10 inches
Setting 12: COPY SCANNING
This setting is used to reduce copies slightly before printing to ensure that
data on the edges are not cut off. Press or to select AUTO for
automatic reduction, or 100% for no reduction, and then press .
♦
Initial setting: 100%
Setting 13: COPY CUT-OFF
This setting determines how the machine will copy documents that are longer
than the printing paper. Select CONTINUE to have the remainder of the
document printed on a second page, or CUT-OFF to cut off (not print) the
remainder. Press or to make the selection, and then press .
♦
Initial setting: CUT-OFF
START/
ENTER
START/
ENTER
START/
ENTER
START/
ENTER
START/
ENTER