Sharp FO-DC500 - Manual (Page 52)

Sending a Fax by Automatic Dialing
50
•
If no numbers have been stored under the entered letter, NOT FOUND will
appear.
•
If multiple fax numbers (or e-mail addresses) have been stored under a
name, press to display the fax numbers and then press or
to select the desired fax number (or e-mail address).
5
Press . The document will be automatically transmitted once the
connection is established.
A
START/
ENTER
Chain Dialing
An auto-dial number set for Chain Dialing can be combined with another auto-
dial number or digits entered manually with the numeric keys to dial one
phone number up to 60 digits long. The following are some examples of how
this can be done:
♦
Press appropriate Rapid Keys in the proper order. For example, press
Rapid Key 01 (set for Chain Dialing), then Rapid Key 02 (not set for Chain
Dialing).
♦
Press a Rapid Key (set for Chain Dialing) and then manually enter a
number by pressing appropriate numeric keys. Press after the final
numeric key to begin transmission.
If the memory becomes full...
If the memory becomes full while a document is being scanned, MEMORY
FULL will appear in the display. If Option Setting 23 (Quick On-line) is set to
ON, scanning will automatically resume when memory becomes free again as
pages are transmitted. (Note: Quick On-Line is initially set to ON at the
factory. To change the setting, see page 195.)
If Quick On-Line is set to OFF the transmission will be canceled and
MEMORY FULL ERROR will appear in the display. Press to clear the
message. Try the transmission again later when memory is free.
START/
ENTER
STOP