Sharp FO-DC500 - Manual (Page 45)

Programming Auto-Dial Numbers
43
2.
Send/Receiv
e
Documents
1
Press and then or
until ENTRY MODE is selected in the
display.
2
Press . Make sure that
DESTINATION SETTING is selected.
3
Press . Press to select
CLEAR.
4
Press .
MENU
START/
ENTER
START/
ENTER
START/
ENTER
Editing auto-dial numbers
To make changes in a number previously stored, repeat the programming
procedure. Select the Rapid Key or Speed Dial number for which you want to
make changes in Step 5, and then change the number(s) and/or name(s)
when they appear in the display (Steps 7 and 9).
Clearing auto-dial numbers
Note: You cannot clear a number if it is used in a program or timer operation,
or if it is included in a Group Key. First clear the number from the operation or
group, then perform the following clearing procedure. To check where the
number is used, print out the Program/Group List or the Timer List as
explained on page 200.
Display:
MENU MODE
1:RECEIVE MODE
2:LISTING MODE
3:ENTRY MODE
ENTRY MODE
01:DESTINATION SETTING
02:PASSCODE SETTING
03:OWN PASSCODE SET
DESTINATION SETTING
1=SET
2=CLEAR
DESTINATION CLEAR
PRESS RAPID OR SPEED