Sony SNC-P5 - Manual (Page 48)

A
d
mini
s
tra
ting
t
he
Came
ra
Sending an Image via mail — e-Mail (SMTP) setting Menu
48
Sending an Image via
mail
— e-Mail (SMTP) setting
Menu
When you click e-Mail SMTP on the Advanced mode
menu, the SMTP setting menu appears.
By using Mail (SMTP) function, you can send a mail
with attached image which has been shot linked with the
external sensor input or with the built-in motion
detection function. The image file can also be sent
periodically.
e-Mail (SMTP) setting menu is composed of three tabs,
Common, Alarm sending and Periodical sending.
Common Tab — Setting the SMTP
Function
e-Mail (SMTP)
Select On when you use the e-Mail (SMTP) function.
The common setting options are displayed below.
If you do not wish to use the e-Mail (SMTP) function,
select Off and click OK.
Notes
• During transmission of an image file via mail, the
frame rate and operation performance of the monitor
image of the main viewer decline.
• While the camera video mode is set to MPEG4, the
image of the composite video signal output from the
video output connector of the camera may be distorted
during mail transmission.
• You cannot send an audio file by using the mail
sending function.
SMTP server name
Type the SMTP server name up to 64 characters, or the
IP address of the SMTP server.
Authentication
Select the authentication required when you send an e-
mail.
Off: Select if no authentication is necessary when an e-
mail is sent.
On: When authentication is necessary an e-mail is sent,
select one of the authentication methods from the
followings.
SMTP: Select if SMTP authentication is necessary
when an e-mail is sent.
POP before SMTP: Select if POP before SMTP
authentication is necessary when an e-mail is
sent.
Note
When you set to On, be sure to select either or both
SMTP or/and POP before SMTP.
POP server name
It is necessary when the POP before SMTP is selected
in Authentication.
Type the POP (receiving mail) server name up to 64
characters, or type the IP address of the POP server. This
setting is necessary when the SMTP server which sends
e-mails performs authentication using the POP user
account.
User name, Password
Type the user name and Password of the user who has
the mail account. This setting is necessary when the
SMTP server which sends e-mails performs
authentication.
Recipient e-mail address
Type the recipient e-Mail address up to 64 characters.
You can specify up to three recipient E-mail addresses.
Administrator e-mail address
Type the Administrator e-Mail address up to 64
characters.
This address is used for reply mail and sending system
messages from the SMTP server.
Subject
Type the subject/title of the e-Mail up to 64 characters.
With respect to mail which is sent according to the alarm
detection when Alarm sending of the alarm tab is set to
On, the characters standing for the sensor type added to
the subject. S1 is added for sensor input1 detection, S2
is added for sensor input2 detection, and MD is added
for motion detection.