Siemens HIPATH V1.2.33 - Manual (Page 60)

Parameters
60
Key
A programmable key can be assigned a function or a speed dial number.
Some keys have already been programmed, for example, with the func-
tions "Disconnect" or "Loudspeaker". You can use up to 17 keys depending
on the phone type. You can assign keys in the Selected_Dialing tab or the
Function Keys tab. Enter a speed dial number or select a function from the
drop-down list.
Key Material File Management
• Write File: Send server certificate to telephone.
• Delete File: Delete server certificate on the telephone.
Layer 2 Voice/Signaling
Voice connection and signaling with Æ Layer 2 support.
Layer 3 Voice/Signaling
• You can only set this if Æ Layer 3 support is active (Æ QoS L2/L3). The
value describes the position in the Æ Layer 2 Priority value.
• Possible values: 0 ... 63.
Layer 2 Default
The default is Æ Layer 2 support.
LAN/PC port mode
• Specify the bandwidths you want the optiPoint phone to use. The nec-
essary value depends on the bandwidth supported by the switch or
router in the network.
• You must restart the tool after making a change.
Language
Select your language in the drop-down list.
Bandwidth Application
10 Mbps half dup For 10-Mbit networks in half duplex mode.
10 Mbps full dup For 100-Mbit networks in full-duplex mode.
100 Mbps half dup For 10-Mbit networks in half duplex
1
mode.
100 Mbps full dup For 100-Mbit networks in full-duplex
2
mode.
Auto negation