Siemens HIPATH V1.2.33 - Manual (Page 67)

Parameters
67
SIP Registrar Address
Enter the corresponding Æ IP Address here.
SIP Registrar Port
Enter the Æ Port number for communicating with the SIP Registrar.
SIP Routing Model
Enter the preferred routing model here. The default value is server mode.
In server mode the telephone uses the Æ IP Address entered to log on to
the SIP server. A dial tone sounds after successful logon.
In gateway mode, the telephone generates a dial tone without logon and
routes all calls to the SIP gateway configured
Æ IP Address.
Æ IP Address is the only option available in direct mode. This mode is
used mainly for test purposes.
SIP Server Address
Enter the Æ IP Address of the SIP server if server mode is active.
SIP Server Port
Enter the Æ Port number for communicating with the SIP Server.
SIP_Transport
You can select the setting Æ UDP or Æ TCP for the SIP transport.
SNMP Password
• Enter the password that was set in the Æ SNMP server as the pass-
word for accessing this server.
• The password must contain between 1 and 24 characters.
• Default password: see Æ Password.