Siemens HIPATH V1.2.33 - Manual (Page 63)

Parameters
63
PBX/Gateway Address
Enter the Æ IP address of the Æ PBX where you want to operate the op-
tiPoint or alternatively the Æ IP address of the gateway. Set the type used.
You can only change the E.164 address by editing "E.164" directly in the
"Operations" directory and not with "Operations Configuration".
Permit Decline Call
Permit user to provide the opportunity, to do facilities in connection with
decline incoming calls.
Port Number
• This can only be configured for optiPoint 410 standard/advance and 600
office HFA, 600 office
UP0/E
, 600 office SIP V2.x.
• If a Æ WAP server is available, enter the Æ Port number here for com-
munication with this server.
Preformed Instant Messages
You can enter up to 20 preformed instant messages here which you can
later select using the "Preformed Instant Messages" function.
Default: blank.
Presence Publishing
Enable or disable the "Presence Publishing" function in conjunction with a
Microsoft LCS for displaying your own presence status.
Default: disabled.
Presence Watching
Enable or disable the "Presence Publishing" function in conjunction with a
Microsoft LCS for displaying the presence status of other contacts.
Default: disabled.
Probe If Allow
You can enable or disable test server mode.
Default: disabled.
Proximity Timer
Contains the length of time in seconds during which the user is displayed
as "Present" after the telephone was used.
Default: 5 seconds