Siemens SCALANCE X-200 - Manual (Page 95)

Diagnostics over Industrial Ethernet
6.2 Web Based Management (WBM)
Figure 6-23 "Switch Ports Status" Dialog
Type Information Box
Displays the type of port. This information is important because difference modules and
therefore different ports can be used in some slots. The following port types are supported:
TP 10 TX
TP 100 TX
FO 100 FX
Mode Information Box
The transmission rate (10 or 100 Mbps) and the transmission mode (for duplex (FD) or half
duplex (HD)).
Negotiation Information Box
Indicates whether autonegotiation is enabled or disabled.
Status Information Box
Indicates that the port is enabled.
Link Information Box
Status of the link to the network. The following alternatives are possible:
• up
The port has a valid link to the network, a link integrity signal is being received.
• down
The link is down, for example because the connected device is turned off.
Industrial Ethernet SCALANCE X-100 and SCALANCE X-200 Product Line
Commissioning Manual, 1,
6-27