Siemens DataNET Hub (DNH) - Manual (Page 85)

2000585-001 Command Summary •••• 77
Command Descriptions, Continued
dn portdelay time
Sets the “port delay” parameter to the
value given, in milliseconds. Actual times
are rounded down to the nearest ten mil-
liseconds.
The dn command is also used to enable and disable software tracing
inside the hub software. This is intended to provide a software debug
facility. The form for these commands is:
dn module on
dn module off
In order to collect software trace events in the log buffer, you must also
give the command “events on.”
dn iframe on
The available modules are:
xlinktrace Traces software events specific to the cross link.
ethertrace Traces software events specific to the Ethernet in-
terface.
dntrace Traces software events for the DataNET driver
lstrace Traces software events in the DataNET section’s
link state module.
rxdonetrace Traces events specific to the “RXDONE” logic.
sattrace Traces software events specific to management of
the Source Address Table (SAT)
iframe Traces software events specific to processing I-
frames in the dn section.