Sharp MD-X60H - Manual (Page 29)

<P=003>
(Continued)
■ APMS recording
1
Select tracks for APMS playback. (Page 23)
2
Load a recordable MiniDisc.
3
Press the CD 0 MD button.
● APMS playback will start, and recording will start automatically.
● Programmed tracks will be recorded in order. After the unit has finished recording
the last track, recording will stop automatically.
● If you press the POLE POSITION button before pressing the CD 0 MD button,
a recording can be made from the beginning of the MiniDisc. (Page 30)
● If recording does not begin, press the CD 0 MD button again. (See page 26.)
POLE
POSITION
MD
3
2
To stop recording:
Press the MD ■ button.
MD
MD 2
1
3
2
1
■ To re-record
When you want to re-record, you can erase a track that is already recorded, starting
from any point in the old track, to begin a new recording. Be aware that when you
do this, all of the tracks and track names that follow the newly recorded track will
be erased.
1
During playback, press the MD 0 6 button at the point where you want to
begin re-recording.
● The unit will pause.
2
Press the MD ● REC button.
● "R. ERASE OK?" will be displayed.
3
Press the ENTER button.
● This unit will be in the recording pause mode.
● To cancel the operation, press the MD ■ button.
4
Select the recording source and start recording.
■ To record without using One-Touch Editing
Without using one-touch recording, the following operation allows you to record
from the first track.
1
Press the CD ■ button.
2
Load a compact disc and a recordable MiniDisc.
3
Press the MD ● REC button.
● The unit will enter the recording stand-by mode.
4
Press the CD 0 6 button.
To stop recording:
Press the MD ■ button.
● After the track number has been written on the MiniDisc, the recording will stop.
However, CD playback will continue.
MD
MD
4
1
3
3
1
4
2
2
MD-X60H(SUK) TINSE0227AWZZ
28