Sharp MD-X60H - Manual (Page 47)

<P=003>
(Continued)
■ Listening to sound from an external unit
AUX
AUX
INPUT LEVEL
VOLUME
VOLUME
MD
MD
1
2
3
4
4
1
To listen to sound from an external unit connected to the digital input
terminal:
1
Press the AUX button.
● Select "AUX OPT.".
2
Start playback on the external unit.
3
Adjust the sound level using the VOLUME buttons on this unit.
To listen to sound from an external unit connected to the analogue
input terminals:
1
Press the AUX button.
● Select "AUX 1" or "AUX 2".
2
Start playback on the external unit, and adjust the input sound level using the
INPUT LEVEL control.
● When the INPUT LEVEL control is set to Min, no sound is obtained.
● The maximum level should not exceed "0 dB".
3
Adjust the sound level using the VOLUME buttons on this unit.
■ Recording sound from an external unit
To start recording the moment the external unit starts playback
(synchro recording):
MD recording will start automatically, as soon as playback starts on the external
unit. This applies to both digital inputs and analogue inputs.
● The space-cut function and auto-mark function will work automatically during
synchro recording.
1
Press the AUX button.
● Select "AUX 1", "AUX 2" or "AUX OPT.".
● Select the input that corresponds to the terminals where the external unit you
will record from is connected.
2
Start the recording on the external unit, and adjust the recording level using
the INPUT LEVEL control. (This is only necessary when recording from anal-
ogue inputs.)
● In the case of digital inputs, it is not necessary to adjust the recording level.
● The maximum level should not exceed "0 dB".
● Adjust the recording level, and then stop the external unit.
3
Load a recordable MiniDisc.
4
Press the SOUND SYNCHRO button.
5
Start playing the music you want to record on the external unit.
● Recording will start automatically.
6
When playback has finished on the external unit, this unit will automatically
enter the recording stand-by mode.
● Cancel the mode by pressing the MD ■ button.
When the MD ■ button is pressed, the TOC will be recorded.
If you want to perform other operations at this point, wait until this display dis-
appears.
To stop recording:
Press the MD ■ button.
Note:
● On some CD players, the track numbers cannot be recorded automatically.
AUX 1 AUX 2 AUX OPT.
AUX 1 AUX 2 AUX OPT.
MD-X60H(SUK) TINSE0227AWZZ
46