Sharp MD-X60H - Manual (Page 52)

<P=002>
(Continued)
MD recording and playback
SYMPTOM POSSIBLE CAUSE REMEDY
● A recording cannot be made. ● Is the MiniDisc protected against accidental
erasure?
● Did you try to make recording on a play-
back-only MiniDisc?
● Can you see the "TOC FULL" message in
the display?
● Slide the accidental erase prevention tab
back to its original position.
● Replace it with a recordable disc.
● Put in another recordable disc with recor-
ding space on it.
● Even though a disc has been loaded, "NO
DISC" or "ERR" is displayed.
● Playback sounds are skipped.
● The disc is very dirty.
● Is the unit located near excessive vibra-
tions?
● Has condensation formed inside the unit?
● Clean the disc.
● Place the unit on a firm, level surface free
from vibration.
● Remove the disc and leave the power
turned on. The unit should function properly
in about 1 hour.
Tape recording and playback
SYMPTOM POSSIBLE CAUSE REMEDY
● A recording cannot be made. ● Is the tape protected against accidental
erasure? ● Cover the accidental erase prevention hole.
● Sound is skipped.
● Sound in high-frequency range cannot be
reproduced.
● Sound quivers.
● The tape is damaged.
● The capstan and pinch roller are very dirty.
● Replace the tape.
● Clean the capsten and pinch roller.
● The cassette cannot be ejected. ● Did a power failure occur? ● Wait until the power is supplied.
Radio reception
SYMPTOM POSSIBLE CAUSE REMEDY
● Radios make unusual noise consecutively. ● The unit is placed near the TV or computer.
● The aerial direction is not placed properly.
● When the unit receives a radio broadcast
near a TV set, a computer or a wordpro-
cessor, it may pick up noise. If this hap-
pens, try to move the unit from the place
where the noise is picked up.
● Correct the aerial direction.
● The preset channel cannot be recalled. ● Did you erase the programmed station? ● Preset the channel again.
● Redo programming.
Remote control
SYMPTOM POSSIBLE CAUSE REMEDY
● The remote control does not function or
does not operate properly. ● The batteries (polarity) are not inserted
properly.
● The batteries inside the remote control are
dead.
● The remote control is operated from an in-
correct distance or angle.
● Insert properly.
● Replace the batteries.
● Operate it within a range of 0.2 m (8") to
6 m (20’) and within an angle of 15
° to
either side of centre.
● The power cannot be turned on from the
remote control. ● Is the AC power lead plugged in? ● Connect the AC power lead.
MD-X60H(SUK) TINSE0227AWZZ
51