Sharp MD-X60H - Manual (Page 45)

YO <P=001>
USING EXTERNAL UNITS
■ Connecting external units
Before connecting external units, set this unit to the stand-by mode and turn off the power to the external units.
Connecting this unit to a CS/BS tuner or a DAT (equipment which can output digital signals)
CS/BS tuner
Optical digital cable (AD-M3DC,
sold separately)
Input socket for
the square plug
DAT
Optical digital cable (AD-M1DC,
sold separately)
This product can be connected to digital equipment such as DATs, CS/BS tuners, other CD players or MD recorders.
● The sampling frequency may be different, depending on the specific piece of digital equipment. (DATs, etc.)
This product automatically adjusts the sampling rate so that it can be used with such equipment.
(Sampling rate converter:32 kHz, 48 kHz
→ 44.1 kHz automatically adjusted)
Connecting to stereos or MD/CD players (equipment which can output analogue signals)
The other MD/CD player
Commercially available lead
with 3.5 mm (1/8") stereo
mini-plug and RCA plugs
T o t h e o u t p u t /
headphone socket RCA lead
LEFT RIGHT RIGHT LEFT
Analogue output sockets
Analogue input sockets
LEFT RIGHT
RIGHT LEFT
● Red plug → To RIGHT
● White plug → To LEFT
RCA lead
Notes:
● When audio input and output signals of an external unit are
connected to this unit, oscillation may occur. In such a case,
disconnect either the input or output connection.
● The signal input from the AUX 2 input sockets is not output
from the output sockets.
Note about making digital copies
This product has a mechanism to keep you from making digital
copies of a MiniDisc (digital input) that was originally recorded
from a CD. This is a requirement of the SCMS (Serial Copy
management System).
● Analogue recording of such a MiniDisc is possible using the
analogue input.
MD-X60H(SUK) TINSE0227AWZZ
44