Image projection, Basic procedure – Sharp XG-C60X User Manual

Page 38

Advertising
background image

Image Projection

▼Keycode input box

-34

Lamp

indicator

Power

indicator

INPUT
button

',", \, |
buttons

MENU
button

ENTER

button

ON button

', ", \, |
buttons

MENU button

ENTER

button

Basic Procedure

Connect the required external equipment to the pro-
jector before operating the following procedures.

Info

•

The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page

36

.

1

Plug the power cord into the

wall outlet.

•

The power indicator illuminates red, and
the projector enters the standby mode.

2

Press

ON

on the projector or on

the remote control.

•

The power indicator illuminates green.
After the lamp indicator illuminates, the
projector is ready to start operation.

Note

•

The lamp indicator illuminates, indi-
cating the status of the lamp.

Green: The lamp is ready.
Green blinking: The lamp is

warming up or
shutting down.

Red: The lamp should be replaced.

•

If the projector is put into the standby
mode and immediately turned on
again, the lamp indicator may take
time to illuminate.

•

When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 40 seconds
after the power has been turned on,
and then transmit the commands.

When “Anti-Theft” (see page

75

) is

set, the keycode input box will appear.

•

Enter the keycode.

Note

•

When entering the keycode, press
the buttons previously set on the
projector or the remote control.

Info

•

When “Anti-Theft” is set, enter the
keycode or the input display will not ap-
pear. Even when the signal is input, the
display will not appear. (see page

75

.)

ON button

XG-C60X_E_PDF_p33_41.p65

03.8.28, 2:08 PM

34

Advertising