Removing and install- ing the lamp unit – Sharp XG-C60X User Manual

Page 90

Advertising
background image

Lamp
unit

BQC-XGC55X//1

User service screw

Removing and Install-
ing the Lamp Unit

Info

•

Be sure to remove the lamp unit by the
handle. Be sure not to touch the glass
surface of the lamp unit or the inside of
the projector.

•

To avoid injury to yourself and damage
to the lamp, be sure to carefully follow
the steps below.

•

Do not loosen other screws except for the
lamp unit cover and lamp unit.
(Only the silver screws are loosened).

•

Please refer to the installation manual
included with the lamp unit.

1

Press

STANDBY

on the projector

or

on the remote control to

put the projector into the
standby mode.

•

Wait until the cooling fan stops.

Warning!

•

Do not remove the lamp unit from the
projector right after use. The lamp will
be very hot and may cause burn or
injury.

2

Disconnect the power cord.

•

Unplug the power cord from the AC
socket.

•

Leave the lamp until it has fully cooled
down (about 1 hour).

3

Change the air filter.

•

Change the air filter whenever you in-
stall the lamp unit (see pages

81

and

82

).

4

Remove the lamp unit cover.

•

Loosen the user service screw that
secures the lamp unit cover. Then
open the cover in the direction of the
arrow.

-86

Regarding the Lamp

AC socket

STANDBY button

STANDBY
button

XG-C60X_E_PDF_p79_93.p65

03.8.28, 2:28 PM

86

Advertising