Konica Minolta IP-711 - Manual (Page 69)

6. Printing
60
6.12 Printing on Paper from Manual Bypass Tray
The Manual Bypass Tray can be selected as the paper source for printing.
1. Select the “Setup” tab.
2. Select “Manual Feed Tray” from the “Paper Source” list.
3. Click “OK” twice to send the job.
4. Load the Manual Bypass Tray of the copier with paper.
NOTES
• Place one sheet of paper at a time.
• An error message will be displayed on the control panel of the copier if a print
job is sent with paper loaded in the Manual Bypass Tray. (In this case, remove
the paper from the Manual Bypass Tray and then reinsert it into the tray.)
• To use paper of A4, B5, or Invoice (5-1/2
×
8-1/2) size, place the paper
crosswise on the Manual Bypass Tray.
(Touching the job displayed on the copier control panel will display
instructions on how to place the paper. Load the paper according as
instructed.)