Kodak DCS Pro 14n - Manual (Page 54)

4-6 April 29, 2004
The Basics
Using the Built-in
Speedlight Use the Speedlight under the following conditions:
• Subject is dark
• Shutter speed is slower than 1/60 second
• Subject is backlit
NOTE: To conserve power, close the Speedlight when it is not in use.
1. Press and rotate the Main-Command dial to set Flash Sync mode
to Front Curtain Sync.
2. Press the Flash Lock-Release button to release the Speedlight.
3. Confirm that an unblinking symbol appears in the viewfinder
(indicating that the Speedlight is ready), then compose, focus, and
capture the image.
If the symbol blinks approximately three seconds after flash,
underexposure may have occurred. Check the flash shooting distance
range (see
page 10-5 ) and repeat step 3.